Leakage!!!!

All aspects of tuning,modification and repairs to the BX 16valve.
User avatar
Simran
4000 rpm
Posts: 424
Joined: Sat Aug 12, 2006 12:30 am
Location: leicester

Post by Simran »

It really isnt that difficult, connect the pipes in the right order and its easy peasy. two plastic pipes that go left across the car first, push the molded block across the subframe towards the rear and connect the two rearward facing plastic pipes, then feed the three up that go to the reservoir then run the one across the subframe to the suspension leg and do the last 2/3 small ones around the right hand side and bobs your uncle.
Vanny
Web Support
Posts: 1570
Joined: Tue Jun 06, 2006 10:11 am
Location: BXProject
Contact:

Post by Vanny »

what about the other one? that description sounds like only the big octopus, but there is another smaller one as well. Usually comes as a set at GSF
User avatar
Simran
4000 rpm
Posts: 424
Joined: Sat Aug 12, 2006 12:30 am
Location: leicester

Post by Simran »

Where does the smaller one go? Only thought there was one, we only got one in the bag from citroen.
surjit25
4000 rpm
Posts: 316
Joined: Thu Feb 07, 2008 3:16 pm
Location: Kuala Lumpur,Malaysia

Post by surjit25 »

There are 2 sets which should be replaced together.
One is power steering return/didvider flow and the other suspension return(octopus).
It is not easy to replace unless you have dainty small hands,
large hands can barely go in there, have a pair of long nose pliers ready.
Post Reply