Here is what I told him along with some pictures of my Car/wheels
Why 15 inch? they look crap,go for the 16 inch ones they will look much better.
.
I can't remember what the offset is of the 206 gti is because it was about 2 year ago when i did it,but i can remember the diffrence was -15mm but the closest hubcentric spacer you can buy is 16mm which is slightly better anyway as the wheels will sit slighty more outboard.The studs are easily available from Rally design,although the nuts are a big problem. You can buy wheel nuts easily but they are all have 60 degree tapered seats and O.E Peugeot wheels have a flat nut seating face so if you used them they would just dig into the wheels and cause damage. The design of Ford RS/Ghia nuts would work but the trouble is although they are M12 the Ford thread pitch is 1.5mm unlike Pug/Citroen which is 1.25mmThe only way around it is to get the wheel bolts off a 206/406 with nimrods and saw the treaded part off completely and then drill them 10.7 mm on a Laithe and tap them M12x1.5mm,also on a laithe to get the thread perfect. this way you can assure that they are secured to the car the way they are designed.Mine are great and work perfect
I can convert you a set of wheel bolts if you send me a set,but due to the amount of time it takes to due I'd have to charge you for my time.
good luck
> Subject: Nimrods on BX 16 valve
> To: richard-nixon
> From: chrisgwilson
> Date: Tue, 1 Mar 2011 14:27:08 +0000
>
> Hello badlyworntoy,
>
> The following is an email sent to you by frog via your account on BX16Valve. If this message is spam, contains abusive or other comments you find offensive please contact the webmaster of the board at the following address:
>
>
> Include this full email (particularly the headers). Please note that the reply address to this email has been set to that of frog.
>
> Message sent to you follows
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~
>
> Hey mate, I'm about to pull the trigger on some 15 inch Nimrods of a 206 gti for my 16 valve.
> I'm just wondering about your comments about their offset and the hubcentric spacers you needed to get:
![Image](http://i1233.photobucket.com/albums/ff395/badlyworntoy/016.jpg)
![Image](http://i1233.photobucket.com/albums/ff395/badlyworntoy/017.jpg)
![Image](http://i1233.photobucket.com/albums/ff395/badlyworntoy/015-1.jpg)
![Image](http://i1233.photobucket.com/albums/ff395/badlyworntoy/015-1.jpg)
![Image](http://i1233.photobucket.com/albums/ff395/badlyworntoy/013.jpg)