door card removal tools required??

All aspects of tuning,modification and repairs to the BX 16valve.
Post Reply
User avatar
Timmo
Full Throttle
Posts: 2233
Joined: Tue Jun 27, 2006 3:30 pm
Location: Cornwall! Tis where they make Oggy's!
Contact:

door card removal tools required??

Post by Timmo »

Morning guys,
question for the knowledgable ones, What toos are needed for he dor cars to come off?? specifically drivers, arethey torx bits?? hoping to get up and sot mine a bit this weekend, drivers doorno longer works formt he outside, think its popped off the handle, just mmasing the tools i'm going to ned to get it going!!!

ta muchly in advance

Timmo.
Timmo 8)

After all i am the Cornish one!

Its Because its French!
Bx16v club - Sharing the love for the unloved!
User avatar
Kitch
5000 rpm
Posts: 737
Joined: Sun Aug 06, 2006 12:52 pm

Post by Kitch »

Torx (can't remember the size....T40?) on mk2 BXs, big fat phillips-head on mk1 BXs. You need quite a long slim reach to get to it too.

And some new clips....you'll need those.
User avatar
Timmo
Full Throttle
Posts: 2233
Joined: Tue Jun 27, 2006 3:30 pm
Location: Cornwall! Tis where they make Oggy's!
Contact:

Post by Timmo »

thanks fella, will chuck the torx drivers in the trug of bits to go then!! :D
Timmo 8)

After all i am the Cornish one!

Its Because its French!
Bx16v club - Sharing the love for the unloved!
User avatar
frog
3000 rpm
Posts: 163
Joined: Sat Feb 26, 2011 2:56 pm
Location: Australia

Post by frog »

I use a small piece of card as well It slips behind the door card to save the paint from the flat blade screw driver.
Post Reply