The rear brake pressure is directly linked to the suspension pressure (so as to self compensate under load) but is there any way to adjust the bias towards the rear?
I'm trying some new brake components at the front but now i'm lacking anchors at the back.
Brake Bias
Brake Bias
Now listen here you mullet...
That'll just make it handle like a Porsche and as much as i'm a keen Botanist i'd really rather not spend too much time in the greeneryVanny wrote:2x 20kg bags of ballast in the rear?
I'm running 30/.5 spheres on the back so do you reckon that's gonna help with the pressure or hinder? The handling is almost as good as i'd like it (if not just a bit too much roll still).
Adding a second subject here seeing as we're touching on it... is it correct that the same-axel struts are connected by hydraulic lines and that capping that connection could reduce roll?
Now listen here you mullet...
changing sphere won't make bugger all difference as the pressure in the strut is toatlly proportional to the weight on the wheels.
So either change strut size, not practical, or fit larger pioston brakes.
Adding a small amount of weight won't make it head for the trees, it'll just settle it better and allow the suspension to work. Adding bags of cement is hardly a performance tweek tho!! but it does help keep them unseized - are you sure yours work anyway? lots are seized through lack of use - thats why a strip and clean is on the service schedule
So either change strut size, not practical, or fit larger pioston brakes.
Adding a small amount of weight won't make it head for the trees, it'll just settle it better and allow the suspension to work. Adding bags of cement is hardly a performance tweek tho!! but it does help keep them unseized - are you sure yours work anyway? lots are seized through lack of use - thats why a strip and clean is on the service schedule