For sale: A leather-clad lovely

Offer your parts and cars for sale here.
Post Reply
User avatar
djoptix
4000 rpm
Posts: 450
Joined: Wed Aug 09, 2006 7:05 pm
Location: Manchester
Contact:

For sale: A leather-clad lovely

Post by djoptix »

...pair of seats are going in the front of my track project 16v, so I have all this stuff for sale. Prices shown are without P&P, you can pick up from either Herefordshire (my parents' ranch) or South Manchester (my house). If you want things posted I can find out cost. Bear in mind it may be a few weeks before I can get stuff, so PM me if interested! Sorry about the crap picture quality. Higher-resolution versions available on request!

I know some of this is tat that I should probably throw out, but maybe someone can use it... incidentally, I really don't know what a lot of this is worth, so please do correct me if I'm overpricing stuff. Ditto underpricing please ;)

And those of you who came to this thread looking for ladies dressed in leather, get off the internet and go and do some work on your BX. It'll thank you for it. :lol:

Right, so...

Full Monza interior in VGC, as you can see it's a bit dusty from being in the garage but it'll clean up fine. Some wear on driver's outside bolster but not too bad. Slight fading on shoulders of rear seats due to the sun. Please note that the seats don't have subframes or belt locks, so you'll need these off your old interior. £60

Image

Image

Image

Centre console, good condition, has a split in the rubber by the handbrake - £5

Image

Homemade custom subframes to mount BX seats in an AX, 106 or Saxo (why??) - £10

Image

16v steering wheel, red Cit badge with a bit of flaking, missing indicator cancel tab but you can add one off another wheel (this one is missing because I had to put it on my ZX 16v wheel) - £5

Image

Boot cavity cover. Incredibly rare, unfortunately also a bit broken. You could probably mend it if you're bothered, but it wouldn't be authentic then... £free

Image

Driver's side electric mirror, I was going to change the manual one on my P1 but can't be bothered now. Pretty sure I tested it working. £5

Image

Fog and mirror control unit - I think this came from the same car as the mirror. £2

Image

BX gearknob with no insert - from lift up reverse car, though I suppose it should work on a non-lift-up-reverse box... £1

Image

BX gearknob with insert, works on anything I should think! £1

Image

Heater control console, OK condition - £free

Image

Roof console with lights - £5

Image

Ignition and fuel filler lock set with two keys - £10

Image

BX 16 valve badge in black - £2

Image

Clock tray with working clock but some damage to plastic around left mounting. £3

Image

Boot light cover with bulb - £1

Image

Fog surround - grubby but salvageable. £2

Image

Front tweeter grilles, intact and in VGC - £3

Image

Rear light clusters in grey, very small crack in the offside one (hardly noticeable) - £5

Image

P1 light clusters in VGC, £5

Image

BX towbar. Made of large ugly - er, I mean strong and well-made - box section. Joking aside, this thing really is built like a brick outhouse. It mounts on the plates either side of the spare wheel cradle. Has two plugs (both of which are currently disconnected) so could be wired for double electrics. £20

Image

Image

Boot carpet, crumpled and needs a hoover, but basically clean. £3

Image

Super rare genuine Citroen headlamp guards. Will clean up nicely, but have small cracks in the inside corners. £5

Image

And finally, rare sunroof visor - £30 or best offer secures.

Image
Red phase 1, 84k
Silver phase 1, 67k
"Man who run in front of car get tyred; man who run behind car get exhausted..."
Mandic
4000 rpm
Posts: 250
Joined: Mon Jul 03, 2006 10:59 am
Location: Ljubljana, Slovenia

Post by Mandic »

Hi,

I'll take mirror control unit and headlamp guards.

YHPM,

Cheers

Ziga
Image Don't run your life on diesel
User avatar
thanuttiscotsman
7000 rpm
Posts: 1137
Joined: Sun Aug 13, 2006 8:16 am
Location: Scotland

Post by thanuttiscotsman »

hi there,
i will defo take the grey lights, lock set, drivers mirror and boot light.

chees rossco
1989 BX 16v ph1 Big project chipped, k+N, scorpion s/s, weber throttle body, Nitrous injection

1990 BX 16v ph2 (now scrapped)
User avatar
thanuttiscotsman
7000 rpm
Posts: 1137
Joined: Sun Aug 13, 2006 8:16 am
Location: Scotland

Post by thanuttiscotsman »

and i will take the clock tray if the clock works.

cheers rossco
1989 BX 16v ph1 Big project chipped, k+N, scorpion s/s, weber throttle body, Nitrous injection

1990 BX 16v ph2 (now scrapped)
User avatar
Toddman
Administrator
Posts: 1318
Joined: Mon Jun 26, 2006 9:02 pm
Location: Lincolnshire
Contact:

parts

Post by Toddman »

Very interested in front seats.

PM sent

Cheers
Luke
Please call me Luke :)
1989 BX 16valve White 70k almost up to scratch
User avatar
thanuttiscotsman
7000 rpm
Posts: 1137
Joined: Sun Aug 13, 2006 8:16 am
Location: Scotland

Post by thanuttiscotsman »

hey man whats happening with this?
1989 BX 16v ph1 Big project chipped, k+N, scorpion s/s, weber throttle body, Nitrous injection

1990 BX 16v ph2 (now scrapped)
User avatar
djoptix
4000 rpm
Posts: 450
Joined: Wed Aug 09, 2006 7:05 pm
Location: Manchester
Contact:

Post by djoptix »

Hey people, sorry for the delay in replying. I will be heading down to the BX later on today so I will sort all this out this weekend. Here's what's sold, and to who:

Boot cavity cover, mirror control unit: sold to Matt H (bxclub). £2 + postage tbc.

Rear light clusters (grey), lock set, driver's mirror, boot light, clock tray: sold to thanuttiscotsman (bx16valve forum). £24 + postage tbc.

Seats, parcel shelf which I forgot to list, steering wheel; sold to nstarmore (bxclub). £60, pickup to be arranged.

Gearknobs x 2; sold to Mark Hughes (bx16valve forum). £2, will bring them back to Manchester this weekend.

Sunroof deflector and headlamp guards; sold to Cossie (bx16valve forum). £35 + postage tbc.
Red phase 1, 84k
Silver phase 1, 67k
"Man who run in front of car get tyred; man who run behind car get exhausted..."
Post Reply