Does anyone know what the pressure the standard FPR runs? Is it 3.0bar or 3.5?
cheers
Standard FPR
reg
Please call me Luke
1989 BX 16valve White 70k almost up to scratch
1989 BX 16valve White 70k almost up to scratch
Kitch
I’m not sure of the new OE-FPR pressure settings. 45psi??
I did a test run while checking a suspect fuel pump.
With a pressure gauge and regulator fitted in-line on the inlet of fuel rail (removed) and using low volume compressed air.
Vacuum pipe disconnect. 45psi, to open the valve, then running at a constant 40psi.
Then acuum applied to FPR – 31psi. Reducing to 25psi as inlet pressure was increased to 60psi.
Hope this may help
Regards
I’m not sure of the new OE-FPR pressure settings. 45psi??
I did a test run while checking a suspect fuel pump.
With a pressure gauge and regulator fitted in-line on the inlet of fuel rail (removed) and using low volume compressed air.
Vacuum pipe disconnect. 45psi, to open the valve, then running at a constant 40psi.
Then acuum applied to FPR – 31psi. Reducing to 25psi as inlet pressure was increased to 60psi.
Hope this may help
Regards
reg
And for the indepth figures download and install the BX16v/mi16 Tech Utility.
http://www.bx16valve.co.uk/19.html
When you run it from your desktop just follow it by selecting citroen and it will lead you to Fuel Pressure where it gives all the ratings.
Cheers
Luke
http://www.bx16valve.co.uk/19.html
When you run it from your desktop just follow it by selecting citroen and it will lead you to Fuel Pressure where it gives all the ratings.
Cheers
Luke
Please call me Luke
1989 BX 16valve White 70k almost up to scratch
1989 BX 16valve White 70k almost up to scratch
- daaristieweer,wiedurft
- Tick Over
- Posts: 32
- Joined: Wed Aug 09, 2006 9:39 pm
- Location: The Netherlands