Page 4 of 4
Posted: Sun May 26, 2013 7:18 pm
by Timmo
they look good but IMO, are too small!
Posted: Mon Jun 10, 2013 11:17 am
by frog
Untitled by
tyro.chris, on Flickr
Gutmann 7J x 15, 195/50/15
Posted: Mon Jun 10, 2013 12:10 pm
by Mike P
Told you they would look good
Mike P
Posted: Mon Jun 10, 2013 4:58 pm
by bxmark
Lovely , lovely , lovely
.
Mark
Posted: Thu Apr 10, 2014 6:17 am
by CoolMaN®
Hi,
I fitted 17" alloy wheels on my car from C4 without problems (6,5J ET26).
Cheers,
Nasko.
Re: Alloy Wheel Fitment
Posted: Sun Aug 24, 2014 12:04 am
by surjit25
Hi, Is the BX havin and offset of 25 or 15?, I think its 25, I have fitted a set of ATS rims with 20 and they touch the fender when at lowest and cant be pushed,
I had a hydraulic leak and it sat totally down and even blistered the paint at the
area where the rubber lining sits in.. yr input please.
Re: Alloy Wheel Fitment
Posted: Mon Aug 25, 2014 7:46 pm
by Timmo
Iirc is 15 on the std alloys??
Re: Alloy Wheel Fitment
Posted: Tue Aug 26, 2014 5:19 pm
by surjit25
Hmm, thanks, if 15in?, someone sent me specs and it said 25?
Re: Alloy Wheel Fitment
Posted: Wed Aug 27, 2014 8:34 am
by Timmo
when i had the 17's they were PSA fitment on et15, fitted spot on except for slightly shot rear arm bearings meant when you reversed they caught the front edge of the fiberglass arch
it was generally assumed that the offset was in the ET15-22 range, Adding a spacer Reduced the Offset, hence why ford wheels and a 20mm spacer fit fine (ET45+20mm spacer =ET25)
Re: Alloy Wheel Fitment
Posted: Thu Aug 28, 2014 5:40 pm
by surjit25
My current ATS rims are 20 and are touching the fender when at lowest level.