BX16V.com Forum

hey fellas, as i am restoring my 16v at present, and its poked P2 bumpers, i have molded the P2 exclusive tail light inserts for the bumper.

These really finish off the rear, and can fit any BX. Dunno if anyone wants a set, but let me know if you, do so i can get an idea of numbers,if any. They look really good on P1 16vs too


[/img]

BUMP.

two of you fellas want these- PM me your postal addresses, and can sort out postage prices etc!

I have made up 4 sets!

one set is for icrc, so three are left...

They are hard urethane-CC60- and will need sanding and painting-they are urethane, so heat them in boiling water, fit them, then take em off and paint em.

For my set i just lined em up in the right spot, marked it, then siliconed them on- for where they are, they dont need screws. Unless you have the holes there already, which is fine, the urethane takes self tappers no problems.