valver induction pipe

Post by **Vanny** » Tue Apr 21, 2009 7:19 pm

Is this the correct induction pipe for the Valver?

Simran · Post by **Simran** » Tue Apr 21, 2009 7:25 pm

Doesnt look like it, i think the valver one is straight with a bend in the end, i'll put a picture up of the right one in a few mins

Simran · Post by **Simran** » Tue Apr 21, 2009 7:35 pm

First pic is a 405 Mi16x4, that looks like the pipe you have, second pic is my car

Hope that helps

Timmo · Post by **Timmo** » Tue Apr 21, 2009 7:36 pm

i think ours is a little longer isnt it?? been a while since i've looked at one mind,
could be one of a 405 mi?? the airbox style on t hem is different to the bx's,

Timmo · Post by **Timmo** » Tue Apr 21, 2009 7:39 pm

beat me to it Simran! i'bve just found the pic i have of the engine bay!

Post by **Vanny** » Tue Apr 21, 2009 11:41 pm

cheers lads, the picture is from an ebay ad and it is listed as being for an Mi16. I couldn't really remember what the BX one should look like, mine is still split! Will have to glue it again i guess.

Any suggestions for a suitable glue?

NZ16v · Post by **NZ16v** » Wed Apr 22, 2009 12:55 am

clean the sh*t out of it with degreaser then thinners, and use polyurethane-the black stuff you get in tubes for a caulking gun. basically set up the inlet in a prone state, and lock it solid somehow,couple of bits of wood either side, big vice etc. Have split facing up, and fill the split, then cover the entire area either side with a 2-3mm skin,as you need as much of a mechanical bond as poss-there will only be a small chemical one, due to the age of the old inlet.You can smooth the urethane down with a kerosene/turps filled brush. My 2 pence!

Post by **Toddman** » Wed Apr 22, 2009 9:54 am

AFAIK the pug item is slightly shorter but can be used especially easy if you have a cone filter.

Cheers
Luke

Post by **Vanny** » Wed Apr 22, 2009 5:37 pm

got an expensive K&N panel filter, which i rather like so shall stick with that for now. Will have a crack at repairing the hose. Cars off the road at the moment so there is no rush!

Timmo · Post by **Timmo** » Thu Apr 23, 2009 8:10 am

almost certain i havent got one but will have a look in the shed dreckly incase i have a spare Vanny, if so i'll send it up!

docchevron1472 · Post by **docchevron1472** » Mon Apr 27, 2009 2:51 am

Sikaflex Vanster.
Cures all known faults with anything EvAh.

Post by **Toddman** » Mon Apr 27, 2009 7:19 am

Best stuff I ever found was called Flexmaster or Dynaflex can't remember now but it as made by Dynasystems.

Cheers
Luke

BX16V.com Forum

BX16V.com Forum

valver induction pipe

valver induction pipe

hose

glue