Hi, interested how the brake thread is going, haven't looked for a while. I have a 16V phase two in which is to some extent being cloned to my own racer. The car is now up and running on 8 x 16 front, 7 x 16 rear Compomotive MOs with graphite grey centres and diamond cut rims, as the original. 288mm discs and matching calipers are fitted and working, nylon rear subframe mounts are in, new genuine spheres on, yet to be made adjustable, Helix six paddle clutch/uprated cover has arrived, Gripper plate LSD too, and a donor car to provide closer third, fourth and fifth gears. Over the next week or so that lot will be done along with an aluminium flywheel, full set of octopus pipes and all the other returns, due for testing on 31st, wish me luck!! 288 brakes take a huge amount of getting used to on the limit.
Cheers
Peter
Brakes again...sorry!!!
-
- Tick Over
- Posts: 26
- Joined: Thu Feb 19, 2009 9:46 pm
- Location: Mytchett
Point taken on higher risks with alloy flywheels, but no plans to fit a poor component or fit a good one badly!! there is an equation that describes the weight and inertia of a rotating mass, anyone who challenges the need to minimise rotating mass in a competition engine has no proper competition experience, and has never driven a well set up alloy flywheel equipped car. even gearchange times can be dramatically reduced, up or down.
Is there an equation describing what happens when the bottom end is out of balance?
I'm not suggesting that a lightened flywheel has no benefit (i'd be tempted to go for dual mass mind) but that if an engine hasn't been blue printed and properly balanced then there is a limit to the benefit of 'add ons'. And hence i would personally go down the blue printing and balancing route before lightening.
And i have seen the difference between a blue printed and an 'as it comes' Mi16 engine and they are miles apart.
I'm not suggesting that a lightened flywheel has no benefit (i'd be tempted to go for dual mass mind) but that if an engine hasn't been blue printed and properly balanced then there is a limit to the benefit of 'add ons'. And hence i would personally go down the blue printing and balancing route before lightening.
And i have seen the difference between a blue printed and an 'as it comes' Mi16 engine and they are miles apart.
-
- Tick Over
- Posts: 26
- Joined: Thu Feb 19, 2009 9:46 pm
- Location: Mytchett