has anyone ever tryed lowering the ride height on their Bx with the anti roll bar slider?
Dont want to waste my time if it doesnt work or breaks teeth
![Confused :?](./images/smilies/icon_confused.gif)
any info greatly reacived
cheers
Not that you'd want to drive the car any distance at all like that.Timmo wrote:the method i used is the Most simplest,
played around with the lever out of its normal slot in the height gate to get a position of which i felt looked the nuts without being on the stops like Low mode is, turned out to be pretty much in the middle of the two low and Normal modes, marked it with a pen,
put the lever into High to get it out the way and avoid me accidentlayy drilling through it which was inevitable knowing me!!! then drilled a pilot hole and then one just a smidge bigger than the diameter of the lever just inside of the edge of the gate (if you look at the ones that are std they are in at an angle to make sure the lever stays there,) then filed off the edges to make it as close to a std one as possible, and Bingo, you have a new Middle mode!