Folks,
If anyone can help I'd be eternally grateful. I'm busy rebuilding the new acquisition and have replaced the engine and harnesses. I've probably left out something obvious as the engine motors but will not fire.
I've not yet got round to checking the obvious such as lack of spark or fuel supply but I've noticed a couple of red connectors by the ECU that seem to go nowhere. Similarly I only recall one relay by the ecu but there are connections for two.
As these may have some relevance I'm curious to find out what they are for but cannot find anything useful on the web. As the fuel pump does not seem to be running this may be a clue but I'm aware the ECU activates the fuel pump..... Thanks.
Motronic M1.3 Wiring Diagram
-
- Tick Over
- Posts: 68
- Joined: Fri Jul 07, 2006 10:44 pm
- Location: Leighton Buzzard, Bedfordshire
Thanks for the reply but I finally sorted this (after a fair chunk of today wasted)....
Fault was an own goal, when wiring the engine bay I crossed the throttle position switch and TDC sensor connectors. As the ECU couldn't see when to fire the ignition it didn't.
Had to bell out all the engine management harness to find this. Managed in the end to cobble together a wiring diagram from various websites that all seem to point to BMW wiring.
Car is a 16V model.
Fault was an own goal, when wiring the engine bay I crossed the throttle position switch and TDC sensor connectors. As the ECU couldn't see when to fire the ignition it didn't.
Had to bell out all the engine management harness to find this. Managed in the end to cobble together a wiring diagram from various websites that all seem to point to BMW wiring.
Car is a 16V model.
Re: Motronic M1.3 Wiring Diagram
Mine the ECU is under the seat but relays/Fuel Pump are in the engine bay at the side of the RHS wheelhouse. (nest to the frt sphere.)dougaldog wrote:Folks,
If anyone can help I'd be eternally grateful. I'm busy rebuilding the new acquisition and have replaced the engine and harnesses. I've probably left out something obvious as the engine motors but will not fire.
I've not yet got round to checking the obvious such as lack of spark or fuel supply but I've noticed a couple of red connectors by the ECU that seem to go nowhere. Similarly I only recall one relay by the ecu but there are connections for two.
As these may have some relevance I'm curious to find out what they are for but cannot find anything useful on the web. As the fuel pump does not seem to be running this may be a clue but I'm aware the ECU activates the fuel pump..... Thanks.
Normally the 8V 1.9 GTi has the 2 relays next to the ECU under the seat.