BX16V.com Forum

Hi everyone
I am in need of the follow in good condition, I have cash but may be able to help you with something you need too.

Monza front seat a pair
Glovebox
Heater duct that runs behind glovebox
Complete steering column shroud with all screws and grommets taht screws drive into, most important is the two grommets that the two TX5 screws drive into behind the steering wheel
Left and right plastic trims that cover te front crossmember that the front seats bolt onto
Rear mudflaps
OE tailpipe, backbox or Sebring back box
16 valve badges both side panel badges abd both tailgate badges

Many thanks
Luke

Hi Luke. Believe there are column bits sitting in the junk pile. May have bits of trunking - is it the triangularish shaped piece that goes to the vent?

Hi Gary
Great to see you , hope you are well? Is your mobile number stil the same?

The duct is the pipe that runs from the passenger air vent along to the heater behind the glove box.

If you plan on visiting Cadwell again please let m eknow would be great to meet up again.

Thanks
Luke

Have emailed some pics over of tailgate badges also column bits.

Nearest we get to you is Snetterton just south of Norwich. It is the next round of the Cannon Tin Tops and Quaife Modifieds.

Thanks Gary, going through emails right now.

I wil try and get my bro to take a run out to Snett, I wil keep yu posted.

Luke

Had not realised how many different badges* appear on tailgates. I'll carefully remove those already mentioned and check other tailgates for any more. Hopefully screws for column bits will be lurking somewhere.

If anyone requires parts from tailgate, bonnet, trim etc let me know and i'll have a look in the "junk" piles.


* 5 so far -

BX 16 Valve
ABS
BX GTi
CITROEN
16V

Hi Gary

I'm also after a full set of badges for the tailgate! So if you have any spare that would be great. If you had a full set of the following that would be great, but the "BX 16 Valve" one is the most elusive

CITROEN
BX 16 Valve
ABS

Let me know if you can be of assistance

Thanks
Rob

I'll have a look for you Rob. Luke some more pics for you in your email.

Hi Luke, how come you need front seats? On the off chance that it's because you have buckets and are returning to standard, I need a pair of buckets and I have a pair of Monza fronts to move on...

Hi Rob
Sorry I don't have nay buckets but I do need the Monxa front seats if you are selling them?

The silver valver was invaded by a family of mice during the winter and they shreeded both front seats and teh rear but I think I have spare rear set.

Thanks Gary, just replied

Thanks
Luke

Mouse damage, gutted! I'm conducting mouse warfare with one as we speak, the little bugger is in the cavity wall...

My seat situation is a bit complicated, in the red one at the moment I have a pair of Monza 16v items re-trimmed in leather, but if I sell them I have to give Kitch first dibs (long story but I bought them when he should have had first refusal on them). On the silver one (er, I've got two now) I have a standard Monza interior. It's not out of the question that I put the leather ones in the silver one, buy some buckets and have some standard Monza fronts spare... But its more likely that I sell the leather ones to Kitchen and buy buckets...

Anyway, I'll let you know ASAP

Gary C wrote:I'll have a look for you Rob. Luke some more pics for you in your email.

Only found the 5 listed so far but still many bits and pieces to trawl through.

Does not help when Xsara stuff seems to have got mixed in with BX bits!

So do you want one of each badge Luke? Plus column parts and duct.

Column bits, duct and badges are on the way to you Luke.

Sorry Rob, the only badge I have left at present is a 16v one.

no worries Gary, many thanks for looking anyway