Page 1 of 1

Rear wheel arch covers

Posted: Mon Jun 21, 2021 6:33 pm
by Gary C
Maybe someone has already looked into this.

Looking to borrow (buy if needs be) a pair of rear arch covers/spats. Want to see if new ones can be made in a small batch run at a reasonable cost.

The ones I have are on the car, and not in the best of nick.

Perhaps the front wing parts could be made as well (I know Chevronics had some new at £40).

Would anyone be interested in any of these parts?

Re: Rear wheel arch covers

Posted: Wed Jun 23, 2021 6:52 pm
by Dave
Hi Gary,

Just so you know someone is seeing your posts, I thought I would respond to this. Right now I am fine but I think they are the type of part that anyone could need at some point because of general depreciation or damage. They would be a nice to have but there are so many bits that would fit that category. If anyone is needing them now and a mould or whatever is created, being able to get more at a later date even at higher cost in fewer or one off orders would be useful.

Let's see what turns up although it's been a bit quiet on here for a while.

Re: Rear wheel arch covers

Posted: Thu Jun 24, 2021 9:38 am
by RobC
I would be interested in the front arch trim for a phase 2 16v- the bit that’s stuck onto the wing just behind the front wheel (near side only, after mine fell off on the A1 a few years back!). Is that the piece you’re referring to?

Re: Rear wheel arch covers

Posted: Sun Jul 11, 2021 4:09 pm
by Gary C
Looking at the whole body kit really but mainly the spats and arches. The skirts are fairly easily repaired so probably not so in demand, plus I have a few spare bits. Front wing spats and rear arch covers have sustained a lot of damage over the years (rubbing is racing some say, I don't agree).