Page 1 of 1
Brake Pad Warnibg Looms
Posted: Thu Oct 05, 2006 3:51 pm
by Toddman
I have 2 branbd new unused brake pad warning wiring looms.
They fit the drivers side of a valver but not the passenger side unless you change the plug that connects to the main loom.
I am told that they will fit a noin ABS passenger side though but I have no idea if this is true.
£10 each including UK postage.
Also a new QH clutch cable for a base model BX £5 + P&P
Cheers
Luke
Posted: Fri Oct 06, 2006 3:02 pm
by djoptix
I think I might need one Luke. The drivers' side brake wiring is in a state! Let me check it, will PM you.
wiring
Posted: Fri Oct 06, 2006 7:05 pm
by Toddman
No probs mate
Lucky you might need just 1 as I can't find the 2nd one LOL! I undid the on ein the puc to take a photo but christ knows where I put the unopened one
Cheers
Luke
Posted: Mon Oct 09, 2006 11:00 am
by djoptix
Can't quite see from your pic but is that a fabric-covered wire that comes off the pad wear sensor? If so, mine is definitely broken.
Posted: Mon Oct 09, 2006 2:50 pm
by Toddman
djoptix wrote:
Can't quite see from your pic but is that a fabric-covered wire that comes off the pad wear sensor? If so, mine is definitely broken.
The brake pads have 2 weave style covered wires that plug into the black rubber connector on the LHS of mu pic.
What usually happens is -
A- the brake pad wires get stuck in the rubber connector and corrosion etc just kills theh rubber part.
B - The rims catches the wiring loom and wears through the cable.
Cheers
Luke